You may need to train your cat at home by putting them in use. You will see how warm and welcoming hotel is there, and before you know it adds to it alone.
We keep our cat houses throughout the year, but we only feed them inside on cold days. I'm stuck all day in winter and at night. In the spring we take it during the day when the weather is hot and put it on cold nights. Use during the summer, our cats inside, so we have put foamPad on the top and from there to love him. If we return to homes in the autumn, as the days and nights begin to cool again, we found our cats sleep inside, they really love their homes!
This house cat is easy to make and can be installed in a few hours. It 'easy to clean and will last for years.
These are the parts needed to build the house, your cat:
1 qt 100. Cooling or higher
1-12 ft rope light super bright
8-1 "x 1" mounting base
20 -Ties
11 - # 8 x 1 / 2 "long wood screws
1 to 8 "x 8" piece of carpet. Make sure the carpet is a few inches taller in height and width as the door will be cut.
1 "thick foam pad for the bed inside (cut to fit)
A rug or a blanket to the bed inside
3 "(cut to fit) thick on the outside on top of the cover
Making the Cat House
Start with the size of a 6 "x 6" square about 1 "from bottom to top, the bottom of the radiator. Then drill a hole in theevery corner big enough for a hacksaw blade fit in. Cut the square.
Mount the piece of carpet inside the radiator with 3 - No. 8 wood screws so that the door is completely covered. Then cut a slit about 3 "in the middle of the carpet. This makes it easier for them to stop.
Install the 8-light tube sockets with No. 8 wood screws, as shown. I tried the tape that is already on the back of the brackets and then hot glue, none of thesetake place, so I decided to use wood screws.
Since the end of the string to string lights around the rope to the inside of the lid in the lower left so that the cable hangs from the back end, as shown in the figure below. Install the bases with their bands. The rope light should wrap twice.
The cable must run the back of the house, with a jigsaw to cut a slit width of the cable into the inner edge of the eyelid and the top of the radiator.
Make sure that theLid closes without pinching the cable. Make sure nick the edge of the lid with the saw.
The best thing is to find the house cat under a covered porch, rain or at least, if you are a board mounted on the tip, above the door.
